SCA: The Hand-Sewn Viking Project, Part II

The second part of my hand sewn Viking outfit project is the smokkr, or apron dress: 

I searched high and low for the right wool, learned a lot about fabrics I almost never use - and then I learned that it was going to be prohibitively expensive to use the wool I wanted for this dress.  So I ended up using a wool "stuff" fabric I had in my stash instead: it's a lightweight diagonal twill, and very smooth, almost like a suiting but not as slick or thin.  On the suggestion of a friend, I ran it through my washer and dryer a couple of times to felt the fabric a bit, which made it thicker and softer, and got rid of the little bit of sheen it started out with.  It’s not perfect, but it’s just fine for this project, which is basically a test-run for a more serious version of this dress that I might make next year. 

Anyway, the pattern for this  dress is the basic three-panel-and-three-gore pattern that the entire SCA uses, which, as near as I can tell, the pattern we use was designed by Carolyn Priest-Dorman (SCA name M. Thora Sharptooth, East Kingdom) in 1993 as a 9th-century Danish apron dress.  FWIU the pattern is based on a combination of viking artwork and on archeologists’ renderings of proposed designs for the garment which were based on grave evidence. 

I went a step further and created a pleated front for this dress, in the style of pieces found at sites like Køstrup and Kaupang.   The exact method the original owners of these garments used to pleat the fabric is not known; I had never pleated anything before so I used the simplest method I found, which was to baste the fabric, draw it together, and then whipstitch over the pleats to hold them in place.  It’s a little uneven, but I think not bad for a first try. 

I finished the top of the dress in two ways. Firstly, because I forgot to hem the top of the dress before I pleated the front, I ended up using a binding strip made of herringbone linen scraps that I had in my stash, which I dyed green.  I then applied a thin tablet woven band to the top edge of the dress between the two brooch loops over the bust. There is evidently some confusion over exactly how this was accomplished on the original Køstrup dress; the band was either suspended between the loops or it was attached to a vegetable diver fabric backing which has since rotted away leaving only the wool band in place. I opted to attach my band to the loops at the top, and whip stitched it to the top edge to help keep it in place. The band itself is cotton and was woven specifically for this project. 

For the shoulder straps and front loops, I used the same fabric as the body of the dress to create a thin double-folded tube, whipstitched closed on the side, following Inga Hagg's sketches of the loops found within the tortoise brooches at Birka: 

Hagg, 1974

I used period stitching methods on this whole dress, like I did for my serk. I used a backstitch for the primary construction seams, a running stitch to attach the linen binding at the top, flat-felled the seams and whip-stitched them in place, and then folded the lower hem and stitched it in place with a herringbone stitch (Inga Hagg's "Osenstitch"): 

Hagg, 1984

This dress has its problems, to be sure. I deviated from my inspiration pieces in areas like fabric choice, and in the use of an edge binding at the top. This was my first time hand sewing an apron dress, hand sewing on wool, and creating pleats/smocking.  Overall, though, I’m pretty happy with the way this turned out, and I can’t wait to wear it with my new serk when the weather cools off a bit! The whole dress took approximately 21 hours to make, including the weaving. 

Whew! Next project!